Troubleshooting - Culligan ClearLink Pro Installation And Operating Instructions Manual

TROUBLESHOOTING

LEAKS AT FILTER/RO INLET OR OUTLET CONNECTION:
A rolled o-ring can block the tube from fully inserting. Use small screw driver to re-seat the o-ring
and then confirm that the end of the tubing has a clean, square cut.
LOW FILTERED WATER FLOW/SYSTEM RETURNS TO UNFILTERED FLOW AUTOMATICALLY:
Low flow rates may not activate the control box electronics. Refer to your system manual to trouble
shoot a low flow condition.
BUTTON IS COMMUNICATING BUT NO CHANGE IN FLOW:
Confirm that the bypass valve is in the down/closed position.
BUTTON COMMUNICATION IS INTERMITTENT:
Some materials may block the wireless signal more than others. Try moving the button to an area on
the counter that is closer to the under-sink control box.
FILTERED WATER FLOW WON'T TURN OFF: Low batteries for the control box can cause the system
to be stuck in the filtered position. The bypass valve can be used to allow unfiltered water flow to the
faucet while the issue is being corrected.
Model: CulRF-M used in devices ClearLink PB and ClearLink D
Contains the FCC ID: V7U-010291CL and IC: 6510B-010291CL
This device complies with part 15 of the FCC Rules subject to the following two conditions: (1) This device may not cause harmful interference (2)
This device must accept all interference received including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This device complies with Health Canada's Safety Code. The installer of this device should ensure that RF radiation is not emitted in excess of the
Health Canada's requirement.
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le programme d'installation de cet appareil doit s'assurer que les rayonnements RF
n'est pas émis au-delà de I'exigence de Santé Canada.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Les changements ou modifications non expressément approuvés par la partie responsable de la conformité pourraient annuler l'autorité de
l'utilisateur à utiliser cet équipement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
10