System Start-Up - Culligan ClearLink Pro Installation And Operating Instructions Manual

SYSTEM STARTUP
Confirm that the bypass valve is in the closed
position (pointed down).
Install four C batteries (not included) into the
battery box and plug into the jack on the bottom
of the control box.
NOTE: The control box will beep and flash the
power light when powering up.
NOTE: AC adapter (01029455) can also be used
where a non-switched outlet is available.
Turn on the cold water supply and check for leaks.
If it leaks, refer to troubleshooting.
Use the provided screw to hang the battery box on
the side of the cabinet.
7