Troubleshooting - Culligan WH-S100-O Installation And Operation Instructions Manual

TROUBLESHOOTING

LEAKS BETWEEN FILTER HEAD AND HOUSING:
1. Turn off water supply and press the red pressure-relief button. Remove bottom of housing.
2. Clean O-Ring and O-Ring groove (located directly beneath threads of housing). Lubricate O-Ring
with clean silicone grease and replace securely into groove. Screw housing into filter head and
hand-tighten. DO NOT OVER-TIGHTEN.
LEAKS FROM INLET/OUTLET CONNECTIONS:
1. Turn off water supply. For brass fittings, tighten nut snugly about 1/2-turn with a wrench.
2. Turn on water supply. If leaks persist, or if there are other leaks on system, turn off water supply.
Call Technical Support at 1-800-721-7360.
FILTER CARTRIDGE SELECTION GUIDE
FILTER SELECTION GUIDE
Select the right cartridge
for your water
PROBLEMS
†
Sediment
†
Rust
†
Scale
†
Dirt
†
Coarse Sand
†
Sand
†
Fine Sand
†
Extra Fine Sand
†
Silt
†
Bad Taste & Odor
Aesthetic Chlorine Taste & Odor
†
Cartridge Life *
†
Micron Rating **
Cartridge Material
Recommended for Well Water
* Cartridge life varies depending on filter type, usage and water
conditions (one month = approximately 4000 gallons).
** The smaller the micron rating, the smaller the size particle the
cartridge will filter. For comparison purposes, the human hair
has a diameter of approximately 70 microns. Particles smaller
than 40 microns are not visible to the human eye.
CW-MF
†
3 months
12,000 gallons
30
Wound
Polypropylene
S-1A CW-F
4 months 3 months
16,000 gallons 12,000 gallons
20 10
Pleated Wound
Cellulose Polypropylene
† Not Performance Tested or Certified by WQA.
10
SCWH-5 P5
3 months 2 months
15,000 gallons 8,000 gallons
5 5
Carbon Spun
Wrapped Polypropylene
P1
2 months
8,000 gallons
1
Spun
Polypropylene