Culligan ClearLink Pro Installation And Operating Instructions Manual page 76

Wireless filtration control, drinking water, agua potable
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING
LEAKS AT FILTER/RO INLET OR OUTLET CONNECTION:
A rolled o-ring can block the tube from fully inserting. Use small screw driver
to re-seat the o-ring and then confirm that the end of the tubing has a clean, square cut.
LOW FILTERED WATER FLOW/SYSTEM RETURNS TO UNFILTERED FLOW AUTOMATICALLY:
Low flow rates may not activate the control box electronics. Refer to your system manual to trouble
shoot a low flow condition.
BUTTON IS COMMUNICATING BUT NO CHANGE IN WATER FLOW:
Confirm that the bypass valve is in the down/closed position.
BUTTON COMMUNICATION IS INTERMITTENT:
Some materials may block the wireless signal more than others.
Try moving the button to an area on the counter that is closer to the under-sink control box.
FILTERED WATER FLOW WON'T TURN OFF:
Low batteries for the control box can cause the system to be stuck in the filtered position.
The bypass valve can be used to allow unfiltered water flow to the faucet while the issue is
being corrected.
If leaks persist, or if there are other leaks from the control box, turn off water supply.
Call technical support at 1-800-721-7360.
PRODUCT REGISTRATION
Please be sure to go online within 30 days of purchase and register your product at
www.register.culligan.com.
Model: CulRF-M used in devices ClearLink PB, ClearLink RI and ClearLink R
Contains the FCC ID: V7U-010291CL and IC: 6510B-010291CL
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents