Making Ip Calls - UTStarcom UTS 702 U User Manual

2-2 Basic Operations
Note: The call timer is for reference only and should not be used in
calculating the cost of a call.
Note: When a phone moves to an area with inadequate signal strength a
warning tone is generated by the handset if the "out of service area alarm"
has been activated.

2.2.1 Making IP Calls

Prior to making an IP call using the
access number; account number and password have been entered into the
memory of the phone.
1. Dial a phone number.
Correct misdialed digits by one of the following methods.
o Press the right soft key
last digit dialed.
o Press and hold down the right soft key
(Clear) for two seconds to delete all dialed digits.
2. Press to send dialed digits. The screen displays
"Connecting."
The LCD on the phone will display a call timer in the lower
left hand corner if the call is successfully completed.
When making a long distance call and the long distance call
lock has been activated, the LCD will display the
Refer to section of "Cancel Long Distance Call Lock" to
release.
3. To end a call or cancel the call attempt, press
soft key . The LCD on the phone will display the call
duration for three seconds and then return to stand-by mode.
1. Dial the number, e.g. 17980
2. Press the key. The phone will automatically send the IP
access number, account number and password stored in memory.
702 U User Manual
(Clear) to delete the
icon.
or the right
key, make sure the correct