Table of Contents
Advertisement
Troubleshooting
Your dryer is capable of diagnosing a number of its own problems.
It will sound a continuous series of beeps and display a code to
alert you that it has a problem that you can correct yourself. To
stop the beeps sounding, press any button on the control panel.
Please do not try to continue your drying cycle once you stop the
alert. You must address the problem the dryer is alerting you to by
referring to this chart.
ERROR DISPLAYS
DISPLAY
"FULL"
Child Lock + "9h"
Child Lock + "6h"
Child Lock + "3h"
TROUBLE SHOOTING
DISPLAY
Pressing the 'On/Off' button does not
turn on the dryer. "FULL"
Dryer does not heat.
Pressing the Play/Pause button does
not start the drying program.
PROBLEM
The water collection tank is full and needs
to be emptied.
Temperature sensor failure
Humidity sensor failure
Heater failure
PROBLEM
Fault with the household power supply
or fuse.
Is your dryer set to the 'Cool' or 'Refresh'
programs?
The dryer may have completed its drying
portion of the cycle and now cooling
down the clothes?
The water tank may be full?
The door may be open or not completely
closed?
The water tank may not be completely
inserted.
The dryer may be experiencing an error.
Delay start may be activated?
Lint filter may be full.
Dryer may be overloaded with clothing.
If you are unable to address your fault by the troubleshooting
steps below, please contact our after sales service team on 1300 2
KOGAN (56426) for further advice.
SOLUTION
Check whether the water collection tank is full and
empty waste water.
If using the bypass hose (drain hose), check whether
the water tank or drain hose is blocked.
If using the bypass hose (drain hose), check that the
hose is still attached at the back of the machine, and
has not become kinked or squashed.
Please contact our after sales service team.
Please contact our after sales service team.
Please contact our after sales service team.
SOLUTION
Try plugging in another electrical appliance in
the same power point and testing.
Refer to this manual for the various drying
programs and try using an alternative program.
-
Empty the water tank.
Check the door is closed completely.
Remove the water collection tank and re-insert
fully.
Refer to the error displays section above.
Check to ensure you haven't inadvertently set
a delay timer for the dryer to begin.
Check the lint filter has been emptied.
Check to ensure the dryer hasn't been
overloaded and try removing some clothing.
16
Advertisement
Table of Contents
