Operating Your Dryer - Kogan KA7HPUMDRYA Instruction Manual

7kg heat pump dryer
Table of Contents

Advertisement

Operating Your Dryer

SELECTING THE PROGRAM
1. Press the On/Off button. The LED display will switch on to
indicate the dryer is on.
2. Rotate the drying program knob to select your desired drying
program.
3. As additional options, you can select Delay, or Anti-crease
functions.
4. To begin drying using your selected settings, press the Start/
Pause button. The dryer door will lock and begin it's program.
NOTE:
Occasionally during operation the spinning drum may pause for
approximately 40 seconds during the drying procedure, but the
LED display will continue as normal. The dryer is automatically
adjusting in this time and will continue operation.
PROGRAM END
1. The drum will stop spinning at the completion of the program.
The LED display will remain alight and a brief audible sound will
indicate the program is complete. Both the "Filter" and "Full"
LED indicators will remind you to clean the lint filters and water
container. The dryer will start Anti-crease function if you don't
remove the clothes in time. Please press the On/Off key to cut off
power and remove the plug from your power point.
2. If there is an unexpected error or malfunction, the dryer will
pause and alert you to an issue. In this case, please deal with the
problem according to the "Troubleshooting" section.
SPECIALTY DRYING FUNCTIONS
Delay Function
1. Load your laundry and make sure the dryer door is closed.
2. Press the On/Off button, then turn the program selector knob
to select your desired program.
3. You can select the Anti-Crease function according to your need.
4. To press the Delay button.
5. Continue to press the Delay to select the delay time.
6. After the Start/Pause button is pushed, the dryer is at the
run condition. The drying procedure will be automatically
performed when the delay time is over.
7. If you push the Start/Pause button again, the delay function will
be paused.
8. If you want to cancel the "Delay" function, please press the On/
Off button.
Anti-Crease Function
At the end of the drying cycle, the anti-crease operation time is 30
minutes (default) or 120 minutes (selected).
The Anti-Crease LED shall light when the anti-crease function is
selected. This function prevents the laundry from creases. The
clothing can be removed during the anti-crease phase and all
other drying programs except for Cool, Refresh, Warm 30' and
Warm 60'.
CHILD LOCK
1. This machine incorporates a special child safety lock, which can
prevent children from carelessly pressing buttons or changing
the selected settings.
2. When the dryer is in operation, press both the Anti Crease
and Delay buttons at the same time for 3 seconds to turn on
the child lock function. When the child lock function is set, no
buttons or dials can alter the selected settings, except the On/
Off button. To deactivate the Child Lock, simply press both the
Anti-Crease and Delay buttons at the same time for 3 seconds.
12

Advertisement

Table of Contents
loading

Table of Contents