Kogan KA7HPUMDRYA Instruction Manual page 10

Installation Instructions Continued
1. Move the machine into the desired position. Do not lift the dryer
by the top panel.
2. Have a minimum clearance on all sides of at least 20 mm.
3. Install the machine on a stable and level floor (if not stacking on
top of a front loading washer).
• Do not install your dryer in such a way that the dryer door
cannot be opened fully.
• Do not install the dryer outside, in a damp place, where there is
a risk of freezing, where it may be rained on, in direct sunlight or
close to a source of heat.
• Do not place your machine on top of its power cable.
LEVELLING THE MACHINE
It is IMPORTANT to level the machine to ensure the machine runs
efficiently with minimal noise. The dryer should be levelled in as
close to its final position as possible so it stands balanced evenly
on all four feet. Ensure the dryer does not rock in any direction.
The dryer comes with four adjustable feet, wind all four feet up
or down until the dryer is correctly level. Use a tool as required,
to assist with unscrewing or screwing the legs. A spirit level can
also assist with this process. The machine is considered level when
the bubble sits in the centre (i.e. within the two lines or the circle),
when the spirit level is placed flat on top of your dryer, in the
directions from:
1. left to right,
2. back to front and
3. corner to corner.
Never unscrew the feet completely from their housings.
YOUR KOGAN DRYER
Note: after levelling, the corners of the dryer cabinet should be
clear of the floor and the machine must not rock in any direction.
DRAINING
The dryer is equipped with a condenser unit which accumulates
water during the drying cycle. This water is collected in the
removable water tank located at the top left of the dryer. The
accumulated water must be emptied after each drying cycle.
However you can also set up your dryer to drain automatically
using the bypass hose (drain hose) provided.
1. Remove the drain hose from the hose connector using pliers.
(Fig. 1)
2. Insert the external drainage hose. (Fig. 2)
3. Put the hose holder on the washing basin or any other sink.
(Fig. 3)
QUICK START GUIDE
10
6
(Figure 1)
(Figure 2)
(Figure 3)