Table of Contents
Advertisement
It is recommended that you allow for an "exclusion zone" of 0.04" (1 mm) around the
RCM4200 in all directions when the RCM4200 is incorporated into an assembly that
includes other printed circuit boards. An "exclusion zone" of 0.08" (2 mm) is recom-
mended below the RCM4200 when the RCM4200 is plugged into another assembly.
Figure A-2 shows this "exclusion zone."
2.50
(63)
2.42
(61)
Exclusion
1.92
Zone
(49)
J3
1.84
(47)
Figure A-2. RCM4200 "Exclusion Zone"
User's Manual
89
Advertisement
Table of Contents
