Menu Settings; Record Setup - Vantrue OnDash T2 User Manual

Note: the Under Voltage Protection only works with 12V
vehicles, doesn't work with 24V vehicles (usually trucks).

4.2 Menu Settings

After powering ON the camera, press the MENU button
to enter the setup process.
(If the camera is recording video, press the OK button to
stop recording before pressing the MENU button.)

Record Setup

A. RECORD SETUP
Press the DOWN button and highlight the Record Setup option.
Press the OK button to enter the settings, and use the UP/DOWN
buttons to navigate the different options.
-Resolution: 1920x1080 (30fps) or 1280x720(30fps). Options are
available.
-Loop Recording: This is set to 3minutes per video clip. Press OK to
change the duration: OFF, 1,3 or 5.
-G-Sensor: Set to Medium by default. Pressing OK gives the following
sensitivity options: Off, Low, Medium, High.
-Audio Recording: Default is ON. Press OK and DOWN button to
toggle it OFF/ON.
-Parking Monitor: Set to Far by default. Pressing OK gives the following
distance options: Far, Middle or Near.
-Exposure: Default is 0. Pressing OK gives the following options: +2.0,
+1.0, +.0, -1.0
GPS Setup
- 10 -
System Setup
Files