Set Date/Time; Loop Recording; Files - Vantrue OnDash T2 User Manual

-Speed Unit: Default is MPH. Press OK to select either KM/H or MP/H.
Press the MENU button to exit and complete the setup.
D. FILES
Review and delete images/videos stored in the file folders.
-EVENT: Critical event videos detected by G-Sensor activity or
manually locked by user.
-NORMAL: Standard videos recorded. In Wave Guard Parking
Monitoring, videos are saved in this file folder.
-PHOTO: Standard images.
-All: All the standard videos, critical event videos and standard
imaged recorded.

4.3 Set Date/Time

Open the MENU interface, navigate to"SYSTEM SETUP"►
"Time & Date", and press the OK button to set the date/
time. Navigate UP or DOWN to select date and time values.
Press OK to confirm and proceed. To finish setup, just press
the MENU button to exit.
Note: Date format is DD/MM/YY with the time in 24 hour
format.
AB

4.4 Loop Recording

After inserting a memory card, the camera will (by default)
immediately start loop recording video when connected to a
power source and powered ON. If the device is not connected
2018 05
13 25
YY / MM / DD
- 12 -
15
21