Transport Jam Occurred During Paper Feeding - Olivetti d-Color P116 Service Manual

(5-3)

Transport jam occurred during paper feeding.

Confirmation Items
(5-3-1) Check the motor operation
Paper feed motor, belt motor,
ID motor, ID up motor
Paper feed motor driver, belt
motor driver, ID up motor driver
Y110260-4
Confirmation Tasks
By using the motor clutch test function of the maintenance utility,
check whether the paper feed motor and belt motor and ID
motor and ID up motor operate normally.
Check whether the load exists.
Pull the HOP connector of main board (TB3 PCB) out, check the
following data on the cable side.
SEVERAL M_Between 1pin-FG
SEVERAL M_Between 2pin-FG
SEVERAL M_Between 3pin-FG
SEVERAL M_Between 4pin-FG
Pull the BELT connector of main board (TB3 PCB) out, check
the following data on the cable side.
SEVERAL M_Between 1pin-FG
SEVERAL M_Between 2pin-FG
SEVERAL M_Between 3pin-FG
SEVERAL M_Between 4pin-FG
Pull the IDUP connector of main board (TB3 PCB) out, check
the following data on the cable side.
SEVERAL M_Between 1pin-FG
SEVERAL M_Between 2pin-FG
SEVERAL M_Between 3pin-FG
SEVERAL M_Between 4pin-FG
d-Color P116 Service Manual
Action at NG
Replace main board
(TB3 PCB) or the paper
feed motor belt motor
ID motor ID up motor or
ID unit Abelt unit with
a new one.
When trying to use a
new belt unit, please
utilize the fuse keep
mode of the
maintenance utility.
(See Note! on page
181.) When trying to
use a new ID unit,
please be careful not to
break the fuse with jig
inside the ID unit.
(Please refer to page
159)
As for paper feed motor
or ID up motor or Belt
motor, Please replace
the main board (TB3
PCB) with a new one.
169