Main Menu - JB Systems CLUBWASH Operation Manual

ENGLISH

MAIN MENU:

• To select any of the pre-set functions, press the [MENU]
button up to when the required one is shown on the display.
• Select the function with the [ENTER] button. The display will
blink.
• Use ▼ and ▲ button to change the mode.
• Once the required mode has been selected, press the
[ENTER] button to confirm. After +/-8 seconds the display
will automatically return to the main functions without any
change.
To go back to the functions without any change press the
[MENU] button. The main functions are shown on the right.
DMX Address
Used to set the starting address in a DMX setup.
• Press the [[MENU]] button until "[Addr]" is shown on the
display.
• Press the [ENTER] button, the display starts blinking.
• Use ▼ and ▲ buttons to change the DMX512 address.
• Once the correct address shows on the display, press the
[ENTER] button to save it.
(or automatically return to the main functions without any
change after 8 seconds)
To go back to the functions without any change press the
[MENU] button again.
Channel Mode
• Press the [MENU] button until "[ChMd]" is shown on the
display.
• Press the [ENTER] button so the display starts blinking.
• Use ▼ and ▲ button to select the one of the available dmx
modes. (5Ch, 9Ch, 15Ch)
• Once the mode is selected, press the [ENTER] button to
setup
(Or automatically return to the main functions without any
change after 8 seconds.)
To go back to the functions without any change press the
[MENU] button again.
Show Mode
Used to choose the Show mode when used in standalone
or master/slave mode.
• Press the [MENU] button until "[ShMd]" is shown on the
display.
• Press the [ENTER] button, the display starts blinking.
• Use ▼ and ▲ buttons to select "Sh 1", "Sh 2", "Sh 3" or
"Sh 4" mode.
• Once the right mode shows on the display, press the
[ENTER] button to save it.
(or automatically return to the main functions without any
change after 8 seconds)
To go back to the functions without any change press the
[MENU] button again.
Show 1 mode- Fixture is placed on the floor. Tilt movement
angle 210°.
Show 2 mode-Fixture is fixed under ceiling. Tilt movement
angle 90°.
Show 3 mode - Fixture is placed on the stage, in front of the
JB SYSTEMS
®
5/11
OPERATION MANUAL
CLUBWASH