Main Menu - JB Systems CLUBSPOT Operation Manuals

ENGLISH
5. [▼] button : press this button to go down in the menu.
6. [▲] button : press this button to go up in the menu.
7. [ENTER]: press this button to confirm the selected function in the menu
8. [SLAVE]: This LED lits when the CLUBSPOT is in Slave mode.
9. [DMX]: This LED lits when a DMX-signal is present.
10. DMX INPUT connector 3pin XLR Male.
11. DMX OUTPUT connector 3p XLR Female.
12. MAINS INPUT with IEC14 socket and integrated fuse holder, connect the
supplied mains cable here.
13. FAN for cooling the electronic components in the base of the machine.

MAIN MENU:

• To select any of the functions, press the [MENU] button and use the ▼ / ▲
buttons to browse the menu.
• Select the function with the [ENTER] button (the display blinks).
• Use ▼ and ▲ buttons to change the mode.
• Once the required mode is selected, press the [ENTER] button to select.
• Press the [MENU] button for about 2 seconds to store the setting and to
return to running mode. If you don't do this, the setting will not be stored
and after about 8 seconds, the fixture will return to the previous running
mode.
DMX Address [Addr]
Used to set the starting address in a DMX setup.
• Press the [MENU] and ▲/▼ buttons until "[Addr]" is shown on the display.
• Press the [ENTER] button.
• Use ▼ and ▲ buttons to change the DMX512 address.
• Once the correct address shows on the display, press the [ENTER] button
to select it.
• Press the MENU button for about 2 seconds to store the setting and to
return to running mode.
Channel mode [ChMd]
Used to set the desired channel setup mode.
• Press the [MENU] and ▲/▼ buttons until "[ChMd]" is shown on the display.
• Press the [ENTER] button.
• Use ▼ and ▲ buttons to choose 5CH, 9CH or 11CH mode.
• Once the desired channel setup mode shows on the display, press the
[ENTER] button to select it.
• Press the [MENU] button for about 2 seconds to store the setting and to
return to running mode.
Show Mode [ShMd]
Used to choose the Show mode when used in standalone or
master/slave. Press the [MENU] and ▲/▼ buttons until "[ShMd]" is showing
on the display.
• Press the [ENTER] button.
• Use ▼ and ▲ buttons to select one of the available shows:
• [Sh 1]: (Show 1) Fixture is placed on the floor. Tilt movement angle
210°.
• [Sh 2]: (Show 2) Fixture is fixed under ceiling. Tilt movement angle
90°.
• [Sh 3]: (Show 3) Fixture is placed on a podium, in front of the
audience. The spot is always projecting to the audience's direction; i.e.
in front of the stage. Pan movement angle (left to right to left): 160°.
Tilt movement angle: 90° (60° above horizon; 30° below horizon.)
• [Sh 4]: (Show 4) Fixture is fixed under ceiling on the stage. The spot
is mainly projecting in front of the stage. Pan movement angle (left to
right to left):160°. Tilt movement angle: 90° (vertically, front 75°; back
JB SYSTEMS
®
4/12
USER MANUAL
CLUBSPOT