JB Systems CLUBWASH Operation Manual page 8

ENGLISH
audience
The spot is always projecting to the audience's direction; i.e. in front of the stage. Pan movement
angle (left to right to left): 160°. Tilt movement angle: 90° (60° above horizon; 30° below horizon.)
Show 4 mode - Fixture is fixed under ceiling.
The spot is mainly projecting in front of the stage. Pan movement angle (left to right to left):160°. Tilt
movement angle: 90° (vertically, front 75°; back 15°)
Slave Mode
Used to make the slave unit work in opposite to the master or to work in complete sync.
• Press the [MENU] button until "[SlMd]" is shown on the display.
• Press the [ENTER] button, the display starts blinking.
• Use ▼ and ▲ button to select "[SL 1]" (normal) or "[SL 2]" (opposite).
• Once the mode is selected, press the [ENTER] button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the [MENU] button again.
Sound State
The unit works to rhythm of the beat when used in standalone or master/slave mode
• Press the [MENU] button until "[Soun]" is shown on the display.
• Press the [ENTER] button, the display starts blinking.
• Use ▼ and ▲ button to select "On" or "Off" mode.
• Once the mode is selected, press the [ENTER] button save it.
To go back to the main menu without any change press the [MENU] button shortly.
If you want to go back to normal running mode: press the [MENU] button for about 2 seconds.
Sound Sense
Used to set the sensitivity of the internal microphone
• Press the [MENU] button until "[SEnS]" is shown on the display.
• Press the [ENTER] button, the display starts blinking.
• Use ▼ and ▲ button to select a value between "0" (very low sensitivity) and "100" (high sensitivity).
• Once the mode is selected, press the [ENTER] button save it.
To go back to the main menu without any change press the [MENU] button shortly.
If you want to go back to normal running mode: press the [MENU] button for about 2 seconds.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in blackout and waits for the DMX-
signal.
No blackout mode: when no DMX-signal is detected, the unit automatically switches to standalone
mode.
• Press the [MENU] button until "[bLMd]" is shown on the display.
• Press the [ENTER] button, the display starts blinking.
• Use ▼ and ▲ button to select "[YES]" (yes blackout) or "no" (no blackout) mode.
• Once the mode has been selected, press the [ENTER] button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the [MENU] button again.
Pan Inversion
Normal: Panning movement is not inverted.
Pan inversion: Panning movement is inverted
• Press the [MENU] button until "[iPAn]" is shown on the display.
• Press the [ENTER] button, the display starts blinking.
• Use ▼ and ▲ button to select "no" (normal) or "YES" (pan inversion) mode.
• Once the mode has been selected, press the [ENTER] button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the [MENU] button again.
Tilt Inversion
Normal: Tilt movement is not inverted.
Tilt inversion: tilt movement is inverted
JB SYSTEMS
®
6/11
OPERATION MANUAL
CLUBWASH