Table of Contents
Advertisement
ENGLISH
MAINTENANCE
• Make sure the area below the installation place is free from unwanted persons during servicing.
• Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
• All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
• When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
• The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
• In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
• Clean with a soft cloth using normal glass cleaning products.
• Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
Power consumption:
Fuse:
Sound Control:
DMX connections:
DMX channels used:
Lamp:
Beam Angle:
Size:
Weight:
You can download the latest version of this user manual on our website:
JB SYSTEMS
®
AC 100 - 240V, 50/60Hz
90 Watt
250V 1A slow blow (20mm glass)
Internal microphone
3pin XLR male / female
5 / 9 / 15 channels
7x 12W RGBWAUV LEDs
25°
see drawing below
3 kg
The information might be modified without prior notice
11/11
OPERATION MANUAL
www.jb-systems.eu
CLUBWASH
Advertisement
Table of Contents
