Table of Contents
Advertisement
Example 2
For situations where the capacitance values are known in advance.
1.
Switch on the 275 and establish connection with Pointek CLS500.
a. Select:
b. Select:
c. Select:
d. Select:
e. Select:
f. Select:
2.
Enter required capacitance value for 0% of the range.
a. Select:
3.
Enter required capacitance value for 100% of the range.
a. Select: Send (the values are now sent)
b. Select: Put loop in manual
c. Select: Return loop to auto
If the DCS and/or the 275 are fitted with the Device Descriptor for Pointek CLS500, more
functions can be used.
The available functions are:
Number
Description
(48)
Read Additional Transmitter Status
(38)
Reset Configuration Changed Flag
(128)
Set Alarm Select
(129)
Adjust for Product Build-up on Sensor
(130)
Read FailSafe mode
(131)
Return device configuration info
(132)
Set Variable Upper Limit
(133)
Set Variable Lower Limit
(134)
Write keylock value
(135)
Read keylock value
(138)
Write simulation time and value
(139)
Read simulation time and value
(140)
Write TV1 Units, URV and LRV
(141)
Read TV1 Units, URV and LRV
(144)
Reset Max/Min recorded PV
(145)
Read Max/Min recorded PV
(150)
Write analog signalling mode
(151)
Read analog signalling mode
(152)
Write digital signalling mode
(153)
Read digital signalling mode
7ML19985GG03
Online
Device setup
Diag service
Calibration
Enter values
PV LRV
PV URV
Pointek CLS500 – INSTRUCTION MANUAL
Page 55
Advertisement
Table of Contents
