Installing And Removing The Rack Handles; Removing The Rack Handles; Installing The Rack Handles; Figure 36. Installing 3.5" Hard Drive Backplane - Install The Stiffener And Hard Drives - Intel JBOD2000S3SP Service Manual

6. Intall the clip to the server chassis (see letter "F").
7. With the lever open, insert the hard disk drive assembly into the chassis (see letter "G"). Push in the lever
to lock it into place (see letter "H"). Repeat step G and H to make sure all hard drive assemblies are in
place.
Figure 36. Installing 3.5" Hard Drive Backplane – Install the Stiffener and Hard Drives
8. Connect cables to the backplane. See "Cable Routing".
2.12

Installing and Removing the Rack Handles

2.12.1

Removing the Rack Handles

Remove the two screws holding the rack handle in place, and remove the rack handle from the server system
as shown.
2.12.2

Installing the Rack Handles

Align the rack handle with the two holes on the side of the server system and attach the rack handle to the
server system with two screws as shown.
18
Intel® Storage Server System JBOD2000S3 Service Guide

Figure 37. Installing the Rack Handle

Figure 38. Removing the Rack Handle