Revolabs Single Channel System Setup Manual

Revolabs Single Channel System - Polycom VSX8000e Setup Guide
N C :
OTES A ND A UTIONS
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom VSX8000e video codec.
1. Connecting the Cables
2. Configuring the VSX8000e Video Codec
It is important to carefully follow these instructions in order and completely.
Note:
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)
3. Polycom VSX8000e video codec
*P VSX 8000
OLYCOM SERIES VIDEO CODECS HAVE PHOENIX CONNECT ORS FOR LINE INPUT WHILE THE
S
SINGLE CHANNEL YSTEM USES
2.5
OFF THE ENDS OF THE MM TO
'
P I R
OLYCOM NTEGRATOR S
RCA
CONNECTORS FOR AUDIO INPUT
RCA
AUDIO CABLE AND CONNECT PER THIS DIAGRAM
EFERENCE MANUAL FOR THE
/ . A
OUTPUT TECHNICIAN COULD SIMPLY CUT
VSX S V 8.7, A
ERIES ERSION
R
EVOLABS
(R
EFERENCED FROM THE
2007):
UGUST