Table of Contents
Advertisement
FX2NC Series Programmable Controllers
3.10
Memory Board installation
Figure 3.12:Installation
1) Turn off the power to the programmable
controller.
2) Remove the cover from the memory board
installation section.
3) Connect the memory board while carefully
inserting the pins.
• Before removing or installing the memory board, be sure to turn off the power.
• If the memory board is removed or installed with the power on, it may be damaged.
• During memory board removal or installation, be careful not to directly touch any
electronic parts.
Figure 3.13:Removal
1) Turn off the power to the programmable
controller.
2) Remove the cover from the memory
board installation section.
3) Slowly pull up the lower section of the
memory board, and completely remove
the board.
Installation notes 3.
3-15
Advertisement
Table of Contents
