Fx 2Nc Run/Stop Control - Mitsubishi FX2NC DSS Series Hardware Manual

FX2NC Series Programmable Controllers
3.2 FX RUN/STOP Control
2NC
RUN or STOP of the FX
The RUN/STOP switch mounted next to the programming port.
A standard input (X0 to X17; X0 to x7 for FX
parameters.
Remotely from a personal computer or other programming peripheral.
Note:The FX
Please refer to table 3.2.
During remote operation the FX
recently operated control.
E.g. If the RUN/STOP switch is in RUN and a remote STOP is made from a personal
computer the RUN/STOP switch must be switched to STOP then back to RUN to
switch the MPU back to RUN mode.
can be controlled by:
2NC
RUN/STOP switch
2NC
-16M
2NC
works in parallel with the RUN-input terminal
RUN/STOP status is determined by the most
2NC
Installation notes 3.
units) defined by the system
3-4
.