Table of Contents
Advertisement
FX2NC Series Programmable Controllers
3.11
Wiring techniques
The wiring of FX
of these products or associated products concern is felt, please contact a professional
electrician who is trained to the local and national standards applicable to the installation site.
Wiring cautions
• Do not run input signals in the same multicore cable as output signals or allow them to
share the same wire.
• Do not lay I/O signal cables next to power cables or allow them to share the same
trunking duct. Low voltage cables should be reliably separated or insulated with regard
to high voltage cabling.
• Where I/O signal lines are used over an extended distance consideration for voltage
drop and noise interference should be made.
products has been designed to be safe and easy. If during the installation
2NC
Installation notes 3.
3-16
Advertisement
Table of Contents
