Reassign The Wireless Propaq Cs To A New Patient; Switch From Wireless To Hardwired Monitoring - Welch Allyn Propaq CS User Manual

Reassign the Wireless Propaq CS to a New Patient

If you want to discontinue monitoring a patient and connect the Wireless
Propaq CS to a new patient, follow these steps.
1. From the Main Menu, press
NEW PATIENT
The monitor then presents a series of menus and messages requesting
you to provide information about the connection and patient. The
actual screens presented depend on how the Acuity System is
configured.
Provide the information as requested. This may include:
• Select an Acuity unit.
• Select a patient from the patient list. (After you select a new patient,
all monitor operating settings are reset to the Acuity System default
powerup settings.)
• Select a patient room from the room list.
If you do not select the patient name or room while connecting the patient,
you will need to do that later at the Acuity Central Station. See the Acuity
System Reference Guide or Acuity Directions For Use for more information.

Switch from Wireless to Hardwired Monitoring

1. Plug the Acuity network cable into the Wireless Propaq CS Acuity
connector and an Acuity bedside network jack.
The Wireless Propaq CS will automatically switch to a hardwired
Acuity network connection. No equipment alerts are generated.
19
SETUP, ACUITY, CHANGE PATIENT,
.
Welch Allyn