Table of Contents
Advertisement
Follow these steps to switch a Wireless Propaq CS monitor from a hardwired
Acuity connection to a wireless Acuity connection.
1. Press the
NET OFF
disconnect from Acuity. (From the Main Menu you can also press
SETUP, ACUITY, END TELE
2. Within 15 seconds unplug the Acuity network cable from the Wireless
Propaq CS Acuity connector and the Acuity bedside network jack.
The Wireless Propaq CS automatically seeks to establish a wireless
connection to the Acuity network.
3. After the network connection is established, select the Acuity Unit,
patient, and room from the Wireless Propaq CS as described on
page 16.
Update
Propaq CS DFU 3.4X
key on the upper left corner of the monitor display to
.)
11
Advertisement
Table of Contents
