Table of Contents
Advertisement
<P=002>
(Continued)
MD recording and playback
SYMPTOM
A recording cannot be made.
Even though a disc has been loaded, "NO
DISC" or "ERR" is displayed.
Playback sounds are skipped.
Tape recording and playback
SYMPTOM
A recording cannot be made.
Sound is skipped.
Sound in high-frequency range cannot be
reproduced.
Sound quivers.
The cassette cannot be ejected.
Radio reception
SYMPTOM
Radios make unusual noise consecutively.
The preset channel cannot be recalled.
Remote control
SYMPTOM
The remote control does not function or
does not operate properly.
The power cannot be turned on from the
remote control.
POSSIBLE CAUSE
Is the MiniDisc protected against accidental
erasure?
Did you try to make recording on a play-
back-only MiniDisc?
Can you see the "TOC FULL" message in
the display?
The disc is very dirty.
Is the unit located near excessive vibra-
tions?
Has condensation formed inside the unit?
POSSIBLE CAUSE
Is the tape protected against accidental
erasure?
The tape is damaged.
The capstan and pinch roller are very dirty.
Did a power failure occur?
POSSIBLE CAUSE
The unit is placed near the TV or computer.
The aerial direction is not placed properly.
Did you erase the programmed station?
POSSIBLE CAUSE
The batteries (polarity) are not inserted
properly.
The batteries inside the remote control are
dead.
The remote control is operated from an in-
correct distance or angle.
Is the AC power lead plugged in?
51
MD-X60H(SUK) TINSE0227AWZZ
REMEDY
Slide the accidental erase prevention tab
back to its original position.
Replace it with a recordable disc.
Put in another recordable disc with recor-
ding space on it.
Clean the disc.
Place the unit on a firm, level surface free
from vibration.
Remove the disc and leave the power
turned on. The unit should function properly
in about 1 hour.
REMEDY
Cover the accidental erase prevention hole.
Replace the tape.
Clean the capsten and pinch roller.
Wait until the power is supplied.
REMEDY
When the unit receives a radio broadcast
near a TV set, a computer or a wordpro-
cessor, it may pick up noise. If this hap-
pens, try to move the unit from the place
where the noise is picked up.
Correct the aerial direction.
Preset the channel again.
Redo programming.
REMEDY
Insert properly.
Replace the batteries.
Operate it within a range of 0.2 m (8") to
6 m (20') and within an angle of 15
either side of centre.
Connect the AC power lead.
to
Advertisement
Table of Contents
