Sharp MD-X60H Operation Manual page 34

<P=004>
(Continued)
4
3
4
2
4
3
5
TAPE
6
5
3
4
APMS recording
1
Select tracks for APMS playback. (Page 23. Steps 1 - 6.)
2
Load a blank cassette into the cassette compartment.
5
3
Press the REVERSE MODE button.
5
... To record on only one side.
... To record on both sides.
2
4
Select the Dolby NR mode by pressing the DOLBY NR button.
When recording with the Dolby NR system, turn on the
When not recording with the Dolby NR system, turn off the
5
Recording from a CD:
Press the CD
Recording from a MiniDisc:
3
Press the MD
Programmed tracks will be recorded in order. After the unit has finished recording
the last track, recording will stop automatically.
Recording from the built-in radio to a cassette tape
1
Tune in to the desired station. (Pages 12 - 13.)
2
Load a blank cassette into the cassette compartment.
Wind past the tape leader which cannot be recorded on.
6
3
Press the REVERSE MODE button.
... To record on only one side.
TAPE
... To record on both sides.
6
4
Select the Dolby NR mode by pressing the DOLBY NR button.
When recording with the Dolby NR system, turn on the
When not recording with the Dolby NR system, turn off the
5
Press the TAPE
" " will flash.
0
6
Press the
To record on both sides, begin on side A (1).
When recording is finished on side A (1), the tape will switch over to side B (2)
automatically.
Beat cancel switch (on the rear panel)
If a whistling noise occurs when recording from an AM station, set the BEAT
CANCEL switch to A or B, whichever gives the best reception.
To stop recording:
Press the TAPE
To interrupt recording:
Press the TAPE
Press the TAPE
33
MD-X60H(SUK) TINSE0227AWZZ
0
TAPE button.
0
TAPE button.
6
button.
1
button to record side A (1), or the button to record side B (2).
button.
6
button.
0 1
button or TAPE button again to resume recording.
G
G
indicator.
indicator.
G
G
indicator.
indicator.