Table of Contents
Advertisement
Saving set point value(s) and comfort
extension time
The control may be manually reset to comfort mode from eco, or night mode. This
allows the user to maintain the daily nominal value for a longer time, e.g. when having
guests. The duration of this comfort extension period is set. After the comfort
extension period is terminated, the system returns to eco mode.
Comfort extension time in seconds
(can only be activated from eco mode)
Set point Comfort
Comfort mode is usually used for daytime mode when people are present. A starting
value is defined for the comfort set point as well as a temperature range in which the
nominal value may be modified.
Initial heating/cooling set point (in 0.1 °C)
valid till 1st communication
not upon saving the set point value after
programming
Min. object value heating/cooling (in 0.1
°C)
Max. object value heating/cooling (in 0.1
°C)
If the comfort set point is used as the basis, a dead zone is determined for the control
mode "heating and cooling" to avoid direct switching from heating to cooling.
Dead zone between heating and cooling
only if both heating AND cooling are used.
Set point for standby
Standby mode is usually used for daytime mode when people are absent.
If set point values are entered separately:
A starting set point value is defined as well as a temperature range in which the
nominal value may be modified.
Initial heating/cooling set point (in 0.1 °C)
valid till 1st communication
Min. object value heating/cooling (in 0.1
°C)
Max. object value heating/cooling (in 0.1
°C)
KNX K8 actuator • Status: 18.11.13 • Technical Changes and Errors excepted.
16
• not
• after voltage recovery
• after voltage recovery and
programming (do not use
for first start-up!)
1...36000; 3600
-300...800; 210
-300...800; 160
-300...800; 280
1...100; 50
-300...800; 210
-300...800; 160
-300...800; 280
Parameter setting
Advertisement
Table of Contents
