Diagnostic Tools - TRENDnet TEW-829DRU User Manual

TRENDnet User's Guide

Diagnostic tools

Administrator > Diagnostics
This section includes network tools and utilities for testing connectivity and
troubleshooting.
1. Log into your router management page (see
on page 8).
2. Click on Administrator and click on Diagnostics.
3. Review the settings below.
Network Utilities
 Ping – This tool conducts a basic ping/connectivity test to a host IP address or
domain name. After selecting and entering all of the required parameters, click
PING to start the connectivity test and the results will appear at the bottom of the
page.
o
Interface – Select the interface used to run the connectivity test.

Default – Uses the internal loopback interface to conduct the
connectivity test.

WAN1/WAN2 – You can select either WAN1 or WAN2 to
conduct the connectivity test through a specific WAN
interface for troubleshooting.
o
Protocol – Select the IP protocol version for the connectivity test, IPv4
or IPv6.
o
Host – Enter the host IP address or domain name to test connectivity.
 Traceroute – This tool conducts a test to check the routing path taken to reach a
specific destination host IP address or domain name. After selecting and entering all
of the required parameters, click TRACEROUTE to start the connectivity test and the
results will appear at the bottom of the page.
o
Interface – Select the interface used to run the connectivity test.

Default – Uses the internal loopback interface to conduct the
connectivity test.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your router management page"

WAN1/WAN2 – You can select either WAN1 or WAN2 to
conduct the connectivity test through a specific WAN
interface for troubleshooting.
o
Protocol – Select the IP protocol version for the connectivity test, IPv4
or IPv6.
o
Host – Enter the host IP address or domain name to test connectivity.
 Nslookup – This tool conducts a test to check domain name resolution to an IP
address. After entering in the domain name to resolve, click NSLOOKUP to start the
resolution test and the results will appear at the bottom of the page.
o
Host – Enter the host IP address or domain name to test resolution.
MWAN Interface Diagnostics – This section allows to conduct connectivity testing on
the multi-WAN configuration.
 Interface – Select the WAN interface to conduct testing.
o
Ping Default Gateway – This will conduct a ping connectivity test to
the default gateway IP address of the selected WAN interface.
o
Ping Tracking IP – This will conduct a ping connectivity test to the
tracking IP configured under Network > Multiple WAN in the Link
Tracking section for the selected WAN interface.
o
Check IP Rules – This will display the current IP rules configured for
the selected WAN interface.
o
Check Routing Table – This will display the current default route
configured for the selected WAN interface.
TEW-829DRU
89