Setting Up The L2Tp Vpn Client (Windows) With Ipsec Encryption (Psk) - TRENDnet TEW-829DRU User Manual

TRENDnet User's Guide
Below is a reference of the additional L2TP VPN server settings if you choose to make
other configuration changes to these sections.

Enable – Check this option to enable the L2TP VPN server.

Local IP – Enter an IP address for the L2TP VPN server. This should be different
from your LAN IPv4 address and any other VLAN IPv4 addresses you are using
on your router. (e.g. 192.168.0.1)

Client IP – Enter the IP address pool to distribute to your L2TP VPN clients after
they establish VPN connectivity. This should be in the same IPv4 subnet used as
your Local IP address. (e.g. 192.168.0.100-192.168.0.254)

Access lan - Checking this option will allow L2TP VPN clients to access the
router LAN IPv4 interface network.

Access vlan – If VLAN IPv4 interfaces are created on your router, they will be
displayed and you can allow L2TP VPN clients access to specific VLAN
interfaces.

DNS Server 1 – Enter the IPv4 address of the primary DNS server to distribute
to L2TP VPN clients after they establish VPN connectivity. This parameter is
optional. (e.g. 8.8.8.8)

DNS Server 2 – Enter the IPv4 address of the secondary DNS server to
distribute to L2TP VPN clients after they establish VPN connectivity. This
parameter is optional. (e.g. 8.8.4.4)

Authentication – Click the drop-down list and select the authentication
protocol to use for L2TP VPN authentication, PAP/CHAP/MS-CHAPv1/MS-
CHAPv2. It is strongly recommended to use MS-CHAPv2 since it offer the
highest degree of security from these options and is supported by most
modern computers and mobile devices.
© Copyright 2018 TRENDnet. All Rights Reserved.

Setting up the L2TP VPN client (Windows) with IPsec encryption (PSK)

Note: This procedure provides a basic example how to setup L2TP with IPsec VPN and
establish connectivity using a Windows® 10 client computer. If you are using a different
operating system or mobile device, please refer to the user's guide/manual of the third
party operating system or device on configuring L2TP with IPsec VPN. The L2TP with
IPsec VPN settings must match with the settings configured on the router.
1. Click the Start button and click the Settings icon.
Start Button Settings icon
2. Click Network & Internet.
3. Click VPN in the left panel.
4. Under VPN, click Add a VPN connection.
TEW-829DRU
68