Ip Filtering - TRENDnet TEW-829DRU User Manual

TRENDnet User's Guide

IP filtering

Network > Firewall > IP Filtering
IP filtering allows you to restrict access to the Internet to specific IP addresses on your
network. You can check the current IP addresses assigned to devices connected to your
router under Status > Overview under the DHCP leases section. You can also lock the IP
address assigned to specific devices connected to your router by
leases or reservations.
1. Log into your router management page (see
on page 8).
2. Click on Network, click on Firewall, and click on the IP Filtering tab.
3. Review the settings below. When complete, click Add to add the new entry to the list
and Apply to save and commit your changes.
 Name – Enter a name for the new IP filtering rule.
 Src IP – This is the source IP address or device IP address to filter. Click the drop-
down list to select a device from the list or enter the local/internal IP address of the
device to filter or restrict.
 Dst IP – This is the destination IP address for the IP filtering rule. Since the IP
filtering rule only applies to outbound Internet access, this will need to be a public
Internet IP. You can leave this setting blank to set the rule to apply to any public
Internet IP address.
© Copyright 2018 TRENDnet. All Rights Reserved.
adding static DHCP
"Access your router management page"
 Protocol – Click the drop-down list to select the protocol for the service to restrict:
All, TCP, UDP, TCP+UDP, or ICMP.
 Src Port – This is the source port number. Enter the source port number for the
service to restrict.
Note: You can also enter a consecutive range of ports in the following format: 80-90
 Dst Port – This is the destination port number. Enter the destination port number
for the service to restrict.
Note: You can also enter a consecutive range of ports in the following format: 80-90
 Schedule – Allows you to select a schedule when the IP filter rule should be enabled
or disabled.
TEW-829DRU
48