Table of Contents
Advertisement
The installation of this heater for use with No.1, No.2, Diesel or Kerosene and
shall conform with local codes or, in the absence of codes, with the National Fuel
Gas Code ANSI Z223.1/NFPA 54. For recommended installation practices refer
to CSA Standard B139.
TOP
3 ft
FUEL:
ELECTRICAL:
INSTALLATION:
CLEARANCE TO COMBUSTIBLES:
FRONT
SIDES
10 ft
1 ft
This heater will operate with No.1, No.2, Diesel or Kerosene.
Note:
No.1 Fuel Oil or Kerosene must be used for
temperatures less than –10º C (8º F).
Electrical Grounding Instructions
This appliance is equipped with a three-prong (grounding)
plug for your protection against shock hazard and should be
plugged directly into a properly grounded three-prong
receptacle.
115v supply must be available. Please note that the heater
requires 15 amps for proper operation. Ensure appropriate
gauge extension cord is used.
• 12/3 AWG at 50 Feet
• 10/3 AWG at 100 Feet
- 4 -
REAR
2 ft
WARNING
FLUE PIPE
3 ft
Hide quick links:
Advertisement
Table of Contents
