Configuring Can Transparent; Overview; Configuring In The Tia Portal - Siemens Simatic Operating Instructions Manual

9.3

Configuring CAN transparent

9.3.1

Overview

Configuring using HSP in the TIA Portal
The PN/CAN LINK is configured in the TIA Portal. The configuration for "CAN transparent"
operating mode mainly consists of the following steps:
1. Import PN/CAN LINK HSP into the TIA Portal.
2. Drag PN/CAN LINK from the HW catalog to the project.
3. Set the PROFINET-specific parameters.
4. Set the "CAN transparent" operating mode.
5. Set the transmission rate.
6. Set the transmit/receive messages and transmit/receive proxies.
7. Check and compile the configuration.
9.3.2

Configuring in the TIA Portal

TIA Portal: Devices & networks
Follow these steps:
1. Select the PN/CAN LINK with its specific article number from the HW catalog
PN/CAN LINK appears in the "Devices & networks" window.
2. Connect the CPU and PN/CAN LINK by means of a PROFINET connection.
CPU and PN/CAN LINK are connected in the "Devices & networks" window with a green
PN line
SIMATIC PN/CAN LINK
Operating Instructions, 03/2018, A5E39895388-AB
②
.
Configuring / programming
9.3 Configuring CAN transparent
①
. The
87