Appendix; Certificates And Approvals - Siemens Simatic Operating Instructions Manual

Appendix

A.1

Certificates and approvals

Note
Approvals are only valid when marked on the product
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type plate.
CE marking
The SIMATIC PN/CAN LINK device conforms to the requirements and safety objectives of
the EC Directives listed below.
EMC Directive 2014/30/EU
The product is designed for operation in residential and industrial areas.
EMC requirements:
Field of application
Residential area
Industrial area
The product meets these requirements if you adhere to the installation guidelines and safety
instructions included in these operating instructions and in the system manual of the
S7-1200 automation system during installation and operation.
General approvals
The current approvals for the PN/CAN LINK are listed in the Siemens Mall.
SIMATIC PN/CAN LINK
Operating Instructions, 03/2018, A5E39895388-AB
Noise emission requirements
EN 61000-6-3
EN 61000-6-4
Interference immunity requirements
--
EN 61000-6-2
A
111