Lutron Electronics Stanza SZ-CI-PRG Installation Instructions

Stanza
TM

Installation Instructions

Occupant Copy Please Read
Features
• Integrates a Stanza guest room lighting control
system with a PC or other digital equipment that
supports RS232 or Ethernet TCP/IP communication.
• Provides a basic serial string command set that
allows a PC to monitor and control lighting. (Details
provided in the Lutron Integration Protocol Guide.)
• Enables use of a PC to set up and commission
Stanza systems.
• Expands Stanza basic system limits from 31 devices
to 100 devices. (Limit one SZ-CI-PRG per system.)
• An SZ-CI-PRG is required for commissioning or
system modification. Programmed and commissioned
systems do not require a SZ-CI-PRG to be present
for continued operation, unless thrid-party serial
integration is required or the number of devices
exceeds 31.
• Wireless connection allows easy mounting of interface
near integration device.
Mounting
1. M ount the interface directly on a wall, as shown in
the Mounting Diagram, using two #6 (M3) screws
(not included). When mounting, provide sufficient
space for the antenna and connecting cables.
Mount in an accessible location for convenient
access to LEDs and electrical connections.
The unit cannot be mounted in a full metal enclosure.
If mounting in a metal enclosure is necessary,
antenna must protrude out of a knockout or other
hole. The antenna may not be removed or mounted
remotely.
2. C onnect wiring as shown in the Wiring Diagram.
LED 1 (Power) lights continuously when the interface
is powered.
Mounting Diagram
Control
interface
Wall
Mounting Hole Detail
0.23
(5.8)
0.31 (7.9)
dia.
0.18 (4.6)
dia.
#6 (M3) screw
recommended
(not included)
SZ-CI-PRG Interface
PELV (Class 2: USA) Device
15 - 24 V 200 mA
Dimensions
Dimensions are in inches (mm).
2.50
(63.5)
3.75
(95.3)
Electrical
connections
on this side
1.06
(26.9)
FCC Information
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television
reception. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• C onnect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by
Lutron Electronics Co. could void the user's authority to operate
this equipment. Operation is subject to the following: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
Mounting
holes
(152.4)
4.26
(108.2)
0.75 (19.1)
5.26
(133.6)
LEDs on this
side
6.0
R