System Setup Procedures; Summary Of Steps - Lectrosonics Dante M2T/E01 Instruction Manual

System Setup Procedures

Summary of Steps

1) Connect power using supplied DCR15/4AU power
supply.
2) Power receiver and scan RF spectrum on site.
3) Sync Scan to transfer information from receiver
to transmitter.
4) Tune transmitter to unoccupied channels in scan.
5) Sync receiver (refer to receiver manual).
6) Turn on transmitter RF.
7) Send audio sources to transmitter.
WARNING: Increasing the Pregain can make
headphone volume excessively loud. Use
caution when setting and using.
Rio Rancho, NM
Digital IEM Transmitter
5