Curve Select Menu - Ametek 7280 Instruction Manual

Chapter 5, FRONT PANEL OPERATION
by pressing Cont. Multi Sweep.
CONT. MULTI SWEEP
This key restarts data acquisition from the current point.
STOP MULTI SWEEP
This key stops data acquisition at the current point. Data already acquired remains in
the curve buffer.
One of the following links to other menus will also be shown, allowing quick access
between the oscillator frequency and amplitude sweep setup menus and the curve
buffer, which is useful when defining oscillator sweeps linked to the curve buffer.
Oscillator
Pressing a key adjacent to this item accesses the Oscillator menu - see section 5.3.09
Setup Frequency Sweep
Pressing a key adjacent to this item accesses the Frequency Sweep menu - see section
5.3.10
Setup Amplitude Sweep
Pressing a key adjacent to this item accesses the Amplitude Sweep menu - see section
5.3.11
Pressing the Previous Menu key returns control to the Main Menu 2.

5.3.23 Curve Select Menu

When the Curve Buffer menu is displayed, pressing the Curve select key accesses the
Curve Select menu, which is shown in figure 5-28.
Figure 5-28, Curve Select Menu
The upper section of the Curve Select menu has a list of sixteen possible data types
5-45