Ametek 7280 Instruction Manual page 72

Chapter 5, FRONT PANEL OPERATION
5-26
Figure 5-16, Configuration Menu, Single Reference Mode
The Configuration menu has three controls used to set the instrument's basic
operating mode and controls to adjust the line-frequency rejection filter's center
frequency, the Noise Measurement mode and the Noise Buffer Length. Changes to
the setting of these controls can be made by using the adjacent
It is also used to access the Communications, Options and Analog Outputs menus.
The relationship of the these menus to Main Menu 1 is shown in figure 5-17. Note
that as with the main menu structure, shown in figure 5-1, it is possible to return to
the Main Display from any menu by pressing the Main Display key, but this has been
omitted from figure 5-17 for the sake of clarity.
Figure 5-17, Configuration Menu Structure
keys.