Removing A Memory Upgrade Module; Checking The Computer Recognition Of New Memory Capacity - Fujitsu P2110 Manual

Critical Point
The memory upgrade module is not something you routinely remove from your LifeBook
notebook. Once it is installed, you should leave it in place unless you want to increase system
memory capacity.

Removing a Memory Upgrade Module

1 Perform steps 1 through 7 of Installing a Memory Upgrade Module.
2 Pull the clips sideways away from each side of the memory upgrade module at the same time.
3 While holding the clips out, remove the module from the slot by lifting it up and pulling towards
the back of your LifeBook notebook.
4 Store the memory upgrade module in a static guarded sleeve.
5 Replace the keyboard by following steps 10 and 11 of Installing a Memory Upgrade Module.

Checking the Computer Recognition of New Memory Capacity

Once you have changed the system memory capacity by either adding or removing a memory upgrade
module, be sure to check that your LifeBook notebook has recognized the change.
You can check the memory capacity by looking at the main menu of the BIOS setup:
1 Turn on the power to your LifeBook notebook using the power switch.
2 Allow the system to start booting and press the F2 key once the Fujitsu logo appears on the
screen. This will open the main menu of the BIOS setup with the current settings displayed. Use
the right arrow key to select Info in the BIOS Setup menu.
52