Power On Self Test Messages - Fujitsu P2110 Manual

Hide thumbs Also See for P2110:
Table of Contents

Advertisement

Power On Self Test Messages

The following is an alphabetic list of error-and-status messages that the Phoenix BIOS and/or your
operating system can generate and an explanation of each message. Error messages are marked
with an *. If an error message is displayed that is not in this list, write it down and check your operating
system documentation both on screen and in the manual. If you can find no reference to the message
and its meaning is not clear, contact your support representative for assistance.
nnnn Cache SRAM Passed
Where nnnn is the amount of system cache in kilobytes successfully tested by the Power On Self
Test. (This can only appear if you have an SRAM PC Card installed.)
*Diskette drive A error or Diskette drive B error
Drive A: or B: is present but fails the BIOS Power On Self Test diskette tests. Check to see that the
drive is defined with the proper diskette type in the Setup Utility, and that the diskette drive is installed
correctly. If the disk drive is properly defined and installed, avoid using it and contact your support
representative.
*Extended RAM Failed at offset: nnnn
Extended memory not working or not configured properly. If you have an installed memory upgrade
module, verify that the module is properly installed. If it is properly installed, you may want to check
your Windows Setup to be sure it is not using unavailable memory until you can contact your support
representative.
nnnn Extended RAM Passed
Where nnnn is the amount of memory in kilobytes successfully tested.
*Failing Bits: nnnn The hex number nnnn
This is a map of the bits at the memory address (in System, Extended, or Shadow memory) which
failed the memory test. Each 1 (one) in the map indicates a failed bit. This is a serious fault that may
cause you to lose data if you continue. Contact your support representative.
*Fixed Disk × Failure or Fixed Disk Controller
Failure (where × = 1-4)
The fixed disk is not working or not configured properly. This may mean that the hard drive type
identified in your setup utility does not agree with the type detected by the Power On Self Test. Run
the setup utility to check for the hard drive type settings and correct them if necessary. If the settings
are OK and the message appears when you restart the system, there may be a serious fault which
might cause you to lose data if you continue. Contact your support representative.
*Incorrect Drive A type–run SETUP
Type of floppy drive A: not correctly identified in Setup. This means that the floppy disk drive type
identified in your setup utility does not agree with the type detected by the Power On Self Test. Run
the setup utility to correct the inconsistency.
70

Advertisement

Table of Contents
loading

Table of Contents