Removing A Memory Upgrade Module; Checking The Memory Capacity - Fujitsu LifeBook T901 Series User Manual

Removing a Memory Upgrade
Module
1. Perform steps 1 through 4 of Installing a
Memory Upgrade Module.
2. Pull the clips sideways away from each side
of the memory upgrade module at the same
time.
3. While holding the clips out, remove the
module from the slot by lifting it up and pulling
towards the rear of your notebook. (Figure
4-5)
Figure 4-5. Removing a Memory Upgrade Module
4. Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover. (Figure 4-4)
6. Replace the screws.
62

Checking the Memory Capacity

Once you have changed the system memory
capacity by either adding or removing a memory
upgrade module, be sure to check that your
notebook has recognized the change.
Your LifeBook T901 Series Tablet PC is designed
to share system memory with video memory,
using Dynamic Video Memory Technology
(DVMT).
As a result, the amount of memory that appears
on your screen is reduced by the amount of
DVMT that have allocated to video memory.
You can check the memory capacity by clicking
[Start] → Control Panel, then double-clicking the
System icon. Select the General tab and check
the amount of memory under "Computer:".
The default 8MB is dedicated to video memory
by Intel Chipset, and if the system has 256 MB of
RAM installed, the display will indicate that there
is 248 MB of RAM installed.
If the total memory displayed is incorrect,
check that your memory upgrade module is
properly installed.