Fujitsu LifeBook P1610 Technical Procedure
System board and heat sink replacement
Hide thumbs
Also See for LifeBook P1610:
- User manual (128 pages) ,
- Bios manual (28 pages) ,
- Technical procedure (9 pages)
Advertisement
Quick Links
LifeBook P1610
System Board and Heat Sink
ESD Precautions are required when working on this LifeBook computer.
Make sure the LifeBook is turned off before beginning this procedure.
1. Turn the LifeBook over and
remove the battery
3. Release the cable by flipping the
latch up.
Replacement
2. Extract these 3 screws from the
Hard Disk Drive cover and lift it off.
4. Lift the Drive out.
Advertisement
Related Manuals for Fujitsu LifeBook P1610
Summary of Contents for Fujitsu LifeBook P1610
- Page 1 LifeBook P1610 System Board and Heat Sink Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over and 2. Extract these 3 screws from the remove the battery Hard Disk Drive cover and lift it off.
- Page 2 5. Extract 11 screws from the lower 6. Extract 2 screws from the rear of case. the LifeBook. 7. Open the LifeBook and lay it flat. 8. Use a plastic pry tool to remove the keyboard upper trim. 9. Lift the top edge of the keyboard 10.
- Page 3 13. Turn the Display back and lay it 14. Disconnect 2 Display cables from down. the system board and the 2 antenna cables from the WLAN Card. 15. Extract 2 screws from the Display 16. Lift the Display off the lower hinge.
- Page 4 21. Disconnect the IO Board cable, 22. Disconnect the CPU fan cable the Bluetooth cable, and the DC from the system board. power cable from the system board. 23. Extract 2 screws from the heat 24. Extract 3 screws from the system sink and lift it out.
- Page 5 29. Turn the system board over, 30. Place the heat sink onto the insert it into the lower case and system board and secure it with 2 secure it with 3 screws. screws. 31. Connect the fan’s cable to the 32.
- Page 6 37. Secure the display with 2 screws 38. Attach the 2 display cables to in the hinge. the system board and the 2 antenna Cables to the WLAN card. 39. Tilt the display up and rotate it ¼ 40. Slide the lower hinge cover into turn.
- Page 7 45. Close the LifeBook and turn it 46. Insert 2 screws into the rear of over. the LifeBook. 47. Insert 11 screws into the lower 48. Insert the Hard Drive. case. 49. Press the latch down to lock the 50. Replace the Drive cover and cable into place.