Removing A Memory Upgrade Module; Checking The Memory Capacity - Fujitsu LifeBook T904 User Manual

Removing a Memory Upgrade Module

Perform steps 1 through 4 of Installing a
1
Memory Upgrade Module.
Pull the clips sideways away from each side of
2
the memory upgrade module at the same
time.
While holding the clips out, remove the module
3
by lifting it up and pulling it away from your
Tablet PC.
Store the memory upgrade module in a static
4
guarded sleeve.
Replace the cover and reinstall the screws.
5

Checking the Memory Capacity

Once you have changed the system memory capacity by replacing the installed module with a larger one, be sure to
check that your notebook has recognized the change.
Check the memory capacity
Panel> System. The amount of memory is displayed next to Installed Memory (RAM): The amount of memory
displayed should be approximately the total of all memory modules installed. There may be a discrepancy which is
allocated for fixed video memory.
I
F THE TOTAL MEMORY DISPLAYED IS INCORRECT
PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT CORRECTLY RECOGNIZED
: from Modern Start screen press [Windows]+[X], then select Control
by doing the following
,
CHECK THAT YOUR MEMORY UPGRADE MODULE IS PROPERLY INSTALLED
79 - Memory Upgrade Module
Figure 43. Removing a Memory Module
, T
SEE ROUBLESHOOTING ON PAGE
. (I
F THE MODULE IS
.
88