Fujitsu P2110 Manual page 81

Problem
The batteries seem to
discharge too quickly.
Shutdown and Startup Problems
The Suspend/Resume/
Power On button does not
work.
The system powers up,
and displays power on
information, but fails to
load the operating
system.
An error message is
displayed on the screen
during the notebook
(boot) sequence.
66
Possible Cause
You are running an application
that uses a great deal of
power due to frequent hard
drive access or DVD/CD-RW
drive access, use of a modem
card or a LAN PC card.
The power savings features
may be disabled.
The brightness is turned all
the way up.
The batteries are very old.
The batteries have been
exposed to high temperatures.
The batteries are too hot or
too cold.
The Suspend/Resume/Power
On button is disabled from the
Advanced submenu of the
Power menu of the setup utility.
You did not hold the button in
long enough.
There may be a conflict with
the application software.
The boot sequence settings of
the setup utility are not
compatible with your
configuration.
You have a secured system
requiring a password to load
your operating system.
Internal hard drive was not
detected.
Power On Self Test (POST)
has detected a problem.
Possible Solutions
Use both the primary battery and an
optional second battery and/or use a
power adapter for this application when
at all possible.
Check the power management and/or
setup utility settings in the Power
Savings menu and adjust according to
your operating needs.
Turn down the brightness adjustment.
The higher the brightness the more
power your display uses.
Replace the batteries.
Replace the batteries.
Restore the notebook to normal
operating temperature. The Charging
icon on the Status Indicator panel will
flash when the battery is outside its
operating range.
Enable the button from the setup utility.
Hold the button longer. This may need to
be a few seconds if your application is
preventing the CPU from checking for
button pushes.
Close all applications and try the button
again.
Set the operating source by pressing
the [ESC] key while the Fujitsu logo is
on screen or use the [F2] key and enter
the setup utility and adjust the source
settings from the Boot menu.
Make sure you have the right password.
Enter the setup utility and verify the
Security settings and modify them as
accordingly.
Use the BIOS setup utility or Primary
Master submenu, located within the
Main menu, to try to auto detect the
internal hard drive.
See the Power On Self Test (POST)
messages to determine the meaning
and severity of the problem. Not all
messages are errors; some are simply
status indicators.