Fujitsu P2110 Manual page 77

Problem
The DVD/CD-RW Access
indicator on the Status
Indicator Panel blinks at
regular intervals when no
DVD/CD-RW disc is in the
tray or the drive is not
installed.
Floppy Disk Drive Problems
You cannot access your
floppy disk.
Hard Drive Problems
You cannot access your
hard drive.
Keyboard or Mouse Problems
The built-in keyboard
does not seem to work.
You have installed an
external keyboard or
mouse, and it does not
seem to work.
62
Possible Cause
The Windows DVD/CD-RW auto
insertion function is active and is
checking to see if a DVD/CD-
RW disc is ready to run.
You tried to write to a write
protected floppy disk.
Floppy disk is not loaded
correctly.
BIOS setup utility states
Diskette Controller: Disabled.
The floppy disk drive may not be
properly installed.
Security is set to protect access
to floppy disk data.
The setup utility is incorrectly set
for your internal (Primary
Master) or optional second hard
drive (Primary Slave).
The wrong drive designator was
used by an application when a
bootable CD-ROM was used to
start the notebook.
Security is set so your operating
system cannot be started
without a password.
The notebook has gone into
Suspend mode.
Your application has locked out
your keyboard.
Your external device is not
properly installed.
Your operating system software
is not setup with the correct
software driver for that device.
Possible Solutions
This is normal. However, you may
disable this feature.
Eject the floppy disk and set it to write
enable.
Eject floppy disk, check orientation
and re-insert.
Revise the setup utility Main menu
settings to enable Diskette Controller.
Remove and re-install your floppy disk
drive.
Verify your password and security
settings.
Revise BIOS settings to set both
Primary Master and Primary Slave
correctly.
Verify drive designator used by
application is in use by the operating
system. When the operating system is
booted from a CD, drive designations
are automatically adjusted.
Verify your password and security
settings.
Push the Suspend/Resume/Power
On button.
Try to use your integrated pointing
device to restart your system. If this
fails, turn your notebook off using the
Power Off button located on the back of
the system. Wait 10 seconds or more,
and then turn the system back on.
Re-install your device.
Check your device and operating
system documentation and activate
the proper driver.