Electromagnetic Compatibility; Electromagnetic Emissions - Satelec Implant Center 2 User Manual

XIII - ELECTROMAGNETIC COMPATIBILITY
Important:
The power cord, the ultrasonic handpiece cords and the multifunction footswitch cord must be kept away
from each other.
I C 2 requires special precautions to be taken with regard to electromagnetic compatibility.
MPLANT ENTER
It must be installed and prepared for use as described in chapter 4.
Certain types of mobile telecommunication devices such as mobile telephones are likely to interfere with the
I C 2.
MPLANT ENTER
The recommended separation distances in this paragraph must therefore be complied with.
I C 2 must not be used near or on top of another device.
MPLANT ENTER
If this cannot be avoided, its operation under the conditions of use must be checked beforehand.
The use of accessories other than those specified or sold by SATELEC as replacement parts may have the
consequence of increasing the emissions or decreasing the immunity of the I

13. 1 ELECTROMAGNETIC EMISSIONS

I C 2 is intended for use in the electromagnetic environment specified in the table below. The user
MPLANT ENTER
and/or installer must ensure that the I
Emission test
RF emission - CISPR 11.
RF emission - CISPR 11.
Harmonic current emission
IEC 61000-3-2.
Voltage fluctuation and flicker
IEC 61000-3-3.
C 2 is used in such an environment.
MPLANT ENTER
Compliance
I C
MPLANT ENTER
Group 1 Therefore, its radiofrequency emissions are very low and are not likely to
cause any interference in nearby equipment.
Class A
I C
MPLANT ENTER
Class A
establishments and those directly connected to the public low voltage
power supply network that supplies buildings used for domestic purposes.
Complies
MPLANT
Electromagnetic environment - guidance
2 uses RF energy for internal operation.
2 is suitable for use in all establishments, except domestic
C 2.
ENTER
25