Checking For Usb Support On The Host Computer; Host Configuration - NCR RealPOS 7199 User Manual

NCR RealPOS 7199 Thermal Receipt Station Printer

Checking for USB Support on the Host Computer

USB interface communications is required and the host computer must be equipped and
set up properly. With the required hardware in place, the Windows POS Ready 2009
operating system natively supports plug–and–play USB with a built–in driver.
Note: You need an Internet access to download the USB drivers from the NCR Web
site: http://www5.ncr.com/support/support_drivers_patches.asp.

Host Configuration

Verify that the proper hardware has been installed in the host PC.
The following steps are applicable to systems running on a Windows POS Ready 7, a
Windows 8, or a Windows 10 operating system:
1. Open the Control Panel.
2. Click the Device Manager.
3. In the Device Manager window, scroll down the list of installed hardware devices
If this entry exists, your host computer is set up for USB operation. If this entry does not
exist, consult your computer documentation to see if USB must be enabled in the BIOS
setup.
until you find an entry for Universal serial bus controller.
19