Self Test - Emerson Rosemount 3300 Series Reference Manual

Rosemount Radar Level Transmitters
VERIFICATION
PROCEDURE

Self Test

Figure 6-1. Use the Self Test
function to verify that no
hardware errors occur.
Device Commands Device Commands
6-2
The Rosemount 3300 transmitter is equipped with diagnostic tools which
facilitate verification of measurement performance. The verification procedure
should include a transmitter self test and an inspection of the waveform plot
described below.
The built-in self test function is available in the RCT program. To run the self
test:
1. Open the Tools section in the RCT workspace Project Bar.
2. Click the Device Commands icon, or choose the Device Commands
option from the View menu.
3. Open the Diag folder and double-click the Self Test option.
4. Verify that the Self Test result is successful.
Tools
Self Test
Reference Manual
00809-0600-4811, Rev AA
February 2009