Grizzly G0855 Owner's Manual page 52

Setting 45° Outward (135°) Stop
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen fence tilt lock, rotate stop block up,
then tilt fence approximately 45° inward onto
stop bolt (see Figure 70).
Stop
Block
Figure 70. Fence set to 45° outward.
-50-
45° Outward
Stop Bolt
Jam Nut
Tilt Lock
3. Place sliding bevel set to 135° against fence
and table, as shown in Figure 71.
Sliding Bevel
Set to 45° Outward
Figure 71. Example of adjusting fence 45°
outward.
4. Loosen jam nut on 45° stop bolt and adjust
stop bolt until fence is exactly 45° outward
while resting on stop bolt (see Figure 70).
Verify angle, then retighten jam nut.
Model G0855/G0856 (Mfd. Since 02/19)