Grizzly G0855 Owner's Manual page 25

17. Attach switch pedestal to stand with (2)
M8-1.25 x 20 cap screws and (2) 8mm lock
washers (see Figure 19).
18. Connect switch cord to motor cord (see
Figure 19).
Note: The switch cord and motor cord have
matching plugs for easy connection.
Switch
Cord
Figure 19. Switch pedestal attached to stand
and cords connected.
19. Install dust port with (4)
head screws and (4)
Figure 20).
x 4
Figure 20. Dust port installed.
Model G0855/G0856 (Mfd. Since 02/19)
Switch
Pedestal
Matching
Plugs
Motor
Cord
Switch
Pedestal
⁄ "-20 x ⁄ " Phillips
1 1
4 2
⁄ " flat washers (see
1
4
20. Slide handwheels onto leadscrews, and
secure with pre-installed 5/16"-18 x 1/2"
Phillips head screws and 5/16" fender wash-
ers (see Figure 21).
Handwheel
(1 of 2)
Figure 21. Handwheel secured to leadscrew
(1 of 2).
21. Verify outfeed table height is set correctly
with knives/inserts at top dead center (TDC)
(refer to Setting Outfeed Table Height on
Page 48) and all knives/inserts are securely
tightened in cutterhead.
Leadscrew
(1 of 2)
x 2
-23-