Grizzly G0855 Owner's Manual page 37

To lower the infeed table below the
pull the release knob (see Figure 33), adjust the
table height, and then tighten the lock to secure
the setting.
⁄ " Depth Stop
1
8
Release Knob
Figure 33. Infeed table height controls.
Depth-of-Cut Scale
The depth of cut can be referenced directly from
the depth scale located on the front of the jointer
(see Figure 34).
Note: The depth scale can be calibrated or
"zeroed" if it is not correct. (Refer to Calibrating
Depth-of-Cut Scale on Page 51.)
Scale
Figure 34. Depth-of-cut scale components.
Infeed Positive Stops
The infeed table has positive-stop screws (see
Figure 35) that allow you to quickly adjust the
infeed table between finish/final cuts and shaping/
heavy cuts and the maximum depth of cut of
(or less) when rabbeting.
Model G0855/G0856 (Mfd. Since 02/19)
⁄ " depth stop,
1
8
Depth of Cut Scale
Scale
Pointer
Positive Stop Screws
⁄ "
1
2
Upper Stop
⁄ " Depth Stop
1
8
Release Knob
Lower
Stop Screw
Lower
Jam Nut
Figure 35. Positive-stop components for infeed
table.
Each positive-stop screw controls top or bottom
range of table movement. Jam nuts lock positive-
stop screws in position so they will not move dur-
ing operation.
We recommend setting the bottom height stop
screw at ⁄ ". The top height stop can be set any-
1
2
where between 0" and
factory set and cannot be adjusted.
Item(s) Needed
Wrench 13mm ................................................... 1
Hex Wrench 4mm .............................................. 1
To adjust infeed positive-stop screws:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen jam nuts on both stop screws (see
Figure 35).
3. Raise table to minimum desired depth of
cut, then tighten upper stop screw (see
Figure 35) until it contacts table. Tighten jam
nut to secure stop screw in position.
4.
Lower table to maximum desired depth of cut,
then tighten lower stop screw until it contacts
table. Tighten jam nut to secure stop screw in
position.
Note: If you need to lower the infeed table
⁄ ", then pull and hold the
more than 1
8
stop release knob (see Figure 35) while low-
ering infeed table.
Screw
Upper
Jam Nut
Table Pin
⁄ ". The ⁄ " depth stop is
1 1
16 8
Qty
⁄ " depth
1
8
-35-